Living in the van - ablutions to sleeping

   Ablutions
Water and washing.   The van has a freshwater tank and a grey water tank. The Grey water tank is stored in the back of the van and can only be accessed through the back doors.The freshwater tank is under the van and is both filled and drained via an outlet underneath.   Yes very odd but that is how it works.

fresh water access

  •  Fresh water access. - see picture above.  To fill tank, close tap, (Tap is in open position in picture,), take off dust cap and attach hose from water source. The hose is in the back of the van. open Van tap and turn on water. When Tank is full, water overflows out the overflow (which you can’t see easily) but you’ll see water pouring onto the ground.  Tank will fill.  When full reverse the process.  Close tap, remove hose, replace drain cap, open tap. To Drain-same thing just don’t attach hose.  
Grey water  container.

        Grey water container. Tank is not mouldy just stained. You can see the toilet cassette in the cupboard. 

I was more frugal with water than Geoff but there is a plastic bowl in the van for washing if you need it. Tea towels and a couple of other towels are included. Most camping grounds have laundry facilities but they do cost money and can be an inconvenience to use. Walking back and forwards 8 times across a wet paddock in Cambridge to try to time it right to get the dryer.  Hmmm.

    Cooking 


The twin burner stove works on denatured alcohol. Not a petrol based fuel. The name for the correct fuel is different in different countries.  I think there are some old labels in the hand book which is in the van.
France : Marine stove fuel. 
Spain:
 UK: Meths.

Do not refill the stove while it is hot or one of the burners is going. You need to pivot up the stove up to access the fuel containers underneath.



 There are a frypan, kettle and pot and various implements and bowls and handbeater etc.  A Thermos is stored in the cupboard next to the fridge. 


  Eating  

There are three tables.
  •          One camping table which is in a long black bag.
  • One large table which fits onto ledge below window and has gray leg support. This support leg needs to be straight, grey locking lever tightened and the bottom of the support leg fits into a small slot on the floor of the van.
  •  The whole arrangement is not strong and it should not be leaned on heavily. The piece of metal which slots into the metal channel under the window is a bit flexible even though it shouldn’t be. This table forms the bottom of the bed when at its lower position. 

Slot to fit leg into to. 

·         Table 3 is a small scale version of this larger one and does not need a leg.  We did not use this one and stored it in the boot of the van.

   

·       Fridge 
  • Is a major frustration in the van.  It is too small to hold a beer and a bottle of white wine and yoghurt and cheese and pate so you have to choose. But as markets etc are fun to go to that is not too bad. It will hold 2 Leffe beer, some milk, cheese and yoghurt and if you want more chiller space   you can always get a small chilly bin. I think I left some chiller pads in the van.  The fridge is quite noisy when it is going so it is good to have it on when you are driving and don’t care. It does hold its temperature well though.  It works off the camper battery and if that battery is not charging properly it will be quickly drained.  Check the section on Electrics. 

·       Heating . A  fuel heater is connected and the hot air comes through vents near the toilet.  We are not sure how it works but it does (turn the rotary temperature controller above the bank of four switches).  We were told it runs on diesel but we are pretty sure it doesn’t.  The fuel container is in the back of the van, and sometime someone needs to figure out exactly what is in it – preferably before they run out and there is nothing to indicate what it was.Good luck!!

·       Radio  The Radio/CDplayer has an IPod or similar  input.  We wish we had bought it to start with - we finally ditched the crappy original and bought the new one once we arrived in the UK in the last part of the trip. There are some CD’s in the van.  We started listening to “Ewen McGregors trip across Europe and Asia” as we drove around Scotland and the UK and found it a good distraction from tedious motorways. Didn’t finish it though so it came home with usJ.  The main control part of the radio etc is in one of the cupboards in the van. It just slots on easily and can be removed just as easily for safekeeping . The stereo handbook is in the big file of guides in the van.


·       Seating
·       The front seats can both swivel round to face the back. The passenger one is much easier to swivel and much more useful once you have done so.  The driver seat back needs to folded forward and the seat base pushed back to turn the seat past the steering wheel. We have taken the arm rests of at least one of the seats as it was loose and a nuisance.
·        The back bench seat has no seat belts but they could probably be fitted.
·       Two folding outdoor chairs are included.  We slid them along the floor behind the front seats or leaned them up against the cupboards with the large mat over them to stop them banging.



·           Sleeping The bed is not an easy one to set up – not the rock-n-roll of some VW vans. But once you get familiar it takes only about 5 mins.
    NB:  Before you do this make sure you have any goodies out of the cupboard at the end of the bench as once the bed is down they are no longer accessible. That was our morning bikkie and breakfast cupboard and if we wanted a cracker with the morning cuppa we had to get it the night before!!
  

Take it in stages.
1.    Push both front seats forward (towards the front of the van) as far as possible and then turn both front seats around. To do this with the driver’s seat you must also fold the back of the seat down as far as it will go so that you can turn it past the steering wheel.   There is a lever on the side of the seat and a handle on the side to make this work.  You will work it outJ
Slotting large table into metal channel see note below

Turning drivers seat. 


  2. Take the large table and carefully fit it into channel/slot low down beneath the window for use with the bed (or on this high up one for when it is being used as a table.
     Inserting table into slot for use as a table or a bed.  NB. The front seats are not turned round in these pictures but they need to be to get the bed made properly. You can also see the metal channel the table is fitting into. There is a similar one at the higher level for normal use.  The table needs to be tilted to fit it into either channel. 

  3.  The table leg needs to be bent at the halfway point - adjust the grey handle to allow this to happen -- and lower the table carefully It will be nearly level with the base of the seats

4.  Now pull the bracket out from the side of the van and swing it across the table top. It will hold the fold down shelf you can see against the window wall which you will soon fold down into the space left by pulling out the bench seat.
  
5.       To tilt the seats you need to pull down on the Grey levers on the 
sides of the seats.













       
6. Take the long headrest out of top of bench seat back. You will need it later but it is easier to get it out before you start moving the back seats around. Try and lever it out as evenly as possible or it will seize. It needs to be placed the same way around into the bench seat. See step 8

small headrest being moved carefully
 7. . Pull the  bench seat forwards, towards the front of the van, as far as it will go by lifting the lever under the seat and pulling the whole base of the seat forwards.
lever under to move seat forward
grey lever on  side to flip seat

8. This base seat has to be flipped over 1800 to fit over the top of table.   Use the grey lever on the side of the seat. Pull this grey lever and tilt the seat base up 90’.  STOP. You can then slot the headrests into the appropriate holes.


  9.The second-most back of the seat backs, back seat panel will flip backwards 900 in the same way as the other back flips forward. – using the grey side levers.

10. Now complete the folding forward of the front and middle parts of the bed before folding down the side cupboard/mattress.

11. There is a black lever on the side of the seat base. It is used to slide the seat towards you – towards the door so that you can then make up the full width of the bed. Pull it right out past its locking point.  Do this NOW. 








   12. Now put the last of the back seat panels down. You will need to force it the last part of the way for it to fit under the frame of the toilet seat (especially if you ignored the previous instruction to pull the bed out past its locking point).
13. NOW push the whole bed BACK towards the window until it locks. See 11.  
14.     You will see a big gap along the window edge and a shelf against the wall. Fold the side shelf down on to the bracket and table and take the long cushion which is stored behind the shelf out and place it along the shelf.  It’s not quite wide enough to fill the gap. Pack it out with the strange shaped cushion. If you ever find somewhere to use this strange shape to its full potential, please let us know.  There is another small cushion which goes at the end under the long thin storage cupboard. We also added another one at the front end to raise it up a bit and squashed the funny shaped cushion into the side to stop a gap forming in the middle of the bed.  
cushion folding down from cabinet

small end cushion
15. Jigsaw now complete.             
cushion stuffed in side to stop falling down gap  .  
the final cushions













The van cupboard over the front seats has a white mattress cover in it which we used on top of the cushions – to try to make it more comfortable and contained. It was OK in this role, and while a foam topper might have been better, storage is an issue.

There are two large pillows and also 2 smaller cushions. One set of double sheets and pillow cases. No Blankets as we used our light weight sleeping bags and we had a mohair blanket which we take everywhere (including back home to the bed in Christchurch).

 At night we also inserted the screens in the front windows. There is one for each side and they enable you to get fresh air but remain secure.


inserting screens
Screens in place in window. 














The van also has Blackout reflecting insulation covers for the front windows. We used these only near the end as they took up space in the van and we used our batik hippy curtains instead. The Insulation blinds attach by suckers which are a bit broken but feel free to use them if you wish.  You do feel as if there is more room in the van at night if you have them up rather than our batik curtains which we just attached in the window and onto the grips above the door. One bit of batik has a small knot in it to attach to a nail above the sliding door.